You can create a RAID driver disk using test. Do you already have an account? Any help will be great Thank you. Connect the data cable to the drive first. Double-check that you have chosen the correct Target Hard Drive. I just enabled everything.
|Date Added:||17 October 2012|
|File Size:||40.36 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
CopyWipe Hard Drives
There are ones that can also attach to SATA drives and ones that come with their own power supplies. ASUS er maar op aan dat ze hun downloads een duidelijkere naam moeten geven. From this point on, continue the install like you normally would with Windows since your SATA hard drive should now be recognized by the system and ready for your Windows installation. If you are unable to manually locate the MakeDisk. The first thing you will need to do is put the motherboard CD that came with your mainboard into your system.
Example of an external USB2 enclosure for a 2.
The files should now be copied over to your floppy disk. The boot order of devices is normally set in the BIOS SetUp by using a specific key press during start-up or in some systems another key press can bring up a boot menu.
Then added device line s to the config. At this point you should have a working SATA drivers disk. Just seeing mkaedisk.exe on the disk should be an indication that the extraction process worked correctly.
creating SATA drivers floppy (Do I need a floppy?)
Nov 8, at 9: MakeDisk will then create your bootable media or ISO image and then display the Success screen shown below. This guide is ok if you have a floppy drive, otherwise you can integrate the drivers into makediso.exe actual CD using this guide witha tool called Nlite.
Depending on the drive and connection it may either be a flat black connection about 1. Select an open drive bay saga the system and mount you new hard drive into the case.
Boot the I chose “test. The key word is probably. Choose Initialize or Write Drive Signature if available. This information can be found at the following link: It will display a message that says: I am going to attempt my own advice shortly. Also if you are currently using the drive through a controller, would it be possible to connect it without the controller for troubleshooting purposes just to see how the capacity is displayed if it is not in the array. Fitting a sata drive Buying a cheap Tbyte as a backup to what you have may be good insurance for protecting the hours involved already.
7 creating a floppy with raid driver | Asus SK8V User Manual | Page /
Look for a file called test. Can anyone help me? Nov 7, at Congratulations you have now installed you SATA hard drive into your system. Once you have it selected you should see several files on the disk. Everything seemed fine, except perhaps a little slower than I amkedisk.exe anticipated, and I noticed that some diagnostic software was reporting my hard drive as a bottleneck.
Windows 7 setup also hang while performing installation. This method of installation is easier than the one presented above as it does not require the use of a SATA drivers disc. While you are going off on floppy drives for sat obsolete, the board you are using is obviously years old itself if it requires SATA drivers to install Windows.
Click next to display the select target screen shown below choose the target location where you want makedisk to. Make sure it feels like it is a snug fit to avoid the chance of the cable falling out if the system is bumped or moved.